What are the main points of using corrugated pipe machine?

Corrugated pipe machine is the production of metal bellows with prestressed engineering concrete equipment, there are a few points in use need to pay special attention to, the next detail for you to introduce.

1, forming rolling spoke adjustment, do not press the spring rod too tight, resulting in too small pitch, and cause too much pressure, so that the motor overload affects the efficiency, long-term operation is easy to burn the motor.

2. The left edge of the forming rolling press out steel strip is cut straight into the root of the spiral sleeve tongue, forming the same Angle with the spiral.

3. The position of the spiral sleeve, the tongue should be at the high point of the circular arc of the die head, and there is no serious friction between the die head and the die head when the die head rotates.

4. When winding the steel belt, use the hand pulley for the buckle of the steel belt.

5. Flanging wheel is placed. The position of the contact die head of the wheel tip should be 2mm away from the tip of the spiral sleeve tongue.

6. The flanging wheel is close to the steel belt, so that the lower fold edge slides away between the flanging wheel and the flanging wheel, and the flanging wheel should not be adjusted with too much force, so as to avoid easy fracturing or pressure flanging wheel.

7. Embossing wheel and spur gear should be based on the Angle of the discount edge, and the direction of the placing wheel and the Angle of the edge should be basically the same. When adjusting, it can be compressed and have obvious indentation.

8. The pressing wheel, according to the buckle of the edge of the pressing edge, the Angle is slightly swung to the right, the strength is tightened by hand, and the pipe is adjusted according to the situation.

Next —

How To Operate The Prestressed Jack Safely?

Return